Idiomas disponibles
Idiomas disponibles
• For drilling in concrete or hard stone, push the switch (3) to the hammer position.
Forward / reverse lever
• To select the forward position (right rotation), push the forward / reverse lever to the
right (R).
• To select the reverse position (left rotation), push the forward / reverse lever to the
left (L).
Variable speed
This tool has a speed control dial (6) that delivers higher speed by turning to the "+" po-
sition and delivers lower speed by turning to the "-" position.
Switching ON and OFF
• Connect the tool to the power supply.
• To start the machine, squeeze the ON / OFF switch (4).
• To stop the machine, release the ON / OFF switch.
Continuous mode
• To switch the machine to continuous mode, keep the on/off switch pressed and at
the same time press the lock-on button (5). Subsequently release the on/off switch.
• To switch off continuous mode, press the on/off switch again.
Never put down the machine when using the continuous mode!
3. MAINTENANCE & CLEANING
CLEANING
• Keep the ventilation slots of the machine clean to prevent the overheating of the
engine.
• Regularly clean the machine housing with a soft cloth, preferably after each use.
• Keep the ventilation slots free from dust and dirt.
• If the dirt does not come off use a soft cloth moistened with soapy water.
• Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
