Idiomas disponibles
Idiomas disponibles
ENGLISH
To set the stepless rotary control
thermostat to the desired room temperature, please
proceed as follows:
1. Set the rotary control
2. Set the function control
or 2.
3. Let the unit run at full power until the desired
room temperature is reached.
4. Slowly turn the control dial
hear a click. This indicates that the heating coils
in the appliance are now switched off, but the
fan continues to work.
The unit now regulates the room temperature
automatically via the room thermostat. The
heating coils switch off automatically when the set
temperature is exceeded and switch on again when
the temperature falls below this.
Note
The desired room temperature should be higher than
the current room temperature.
Switch off the unit
1. Set the stepless control dial
thermostat to min.
2. Set the function control
it run for a few minutes to cool down the unit.
3. Switch off the unit by setting the function
control
to 0.
2
4. Pull the mains cable out of the socket by the
mains plug.
5. Disconnect the extension cable from the heater.
6. Let the unit cool down completely.
24
of the room
1
to max.
1
to heating level 1
2
back. You will
1
of the room
1
to the fan
and let
2
