Idiomas disponibles
Idiomas disponibles
Assembly & commissioning
Delivery
Remove the unit from the packaging and completely
remove all packaging parts from the unit.
Unwind the mains cable completely and make sure
that it is not damaged.
Warning Danger of suffocation!
Keep packaging parts out of the reach of children and
dispose of them as soon as possible.
Note
Please have visible damage to the outer packaging
confirmed by the driver of the parcel service
immediately upon delivery. If transport damage is only
noticed during unpacking, the parcel service must be
notified in writing within 24 hours of delivery in order
to hold them liable for the damage.
Assembly
Before you can set up the unit, the feet, the axle with
castors, as well as the handle and the locking screw for
the discharge angle must be fitted.
You will find an illustrated illustration on page 6-7 of this
manual.
Proceed as follows for assembly:
1. Attach the two brackets
with the corresponding fasteners
correct direction of the brackets in order to be
able to mount the axle at the rear end. (p. 6, fig. 1)
Screw the locking screw with the fasteners
the heater
through the brackets
A
6, picture 1)
2. Mount the handle
C
brackets
. (p. 6, picture 2)
B
3. Insert the wheel axle
provided in the brackets
castors
on it with the fasteners
E
axle with the two cotter pins
to the heater
A
B
I
. Ensure the
to
H
as well. (p.
B
with the fasteners
on the
J
through the holes
D
and mount the
B
. Secure the
F
. (p. 7, picture 3)
G
Commissioning
When installing the unit, the prescribed minimum
distances must be observed,
See the graph below.
min. 60 cm
min. 60 cm
min. 60 cm
min. 200 cm
Position the fan heater so that it is upright on a solid
surface and a safe distance away from damp environ-
ments and flammable objects.
Note
When you operate the heater for the first time, there
may be a slight emission of smoke. This is quite normal
and will stop after a short time. The heating element
is made of stainless steel and was coated with a
protective oil during manufacture. The smoke is caused
by the remaining oil during heating. There may also be
an odour here. This is also normal and will fade.
Electrical connection
The heater is supplied with an industrial plug installed
in the unit. An additional coupling or extension cable is
required to use the heater.
The following must be observed here:
Y
X
X
CEE coupling 380V/415V 50/60Hz (32A)
Y
Mains cable: H07RN-F 4G2.5mm
CEE plug 380V/415V 50/60Hz IP24 (32A)
Z
The user should use the purchased mains coupling as
shown in the illustration. The coupling should fit the unit
and extend the earth connection. The coupling should
be VDE approved. The length of the mains cable may be
more than 1.8 m but less than 3 m. If the mains cable is
ENGLISH
min. 60 cm
Bild 1
Z
2
21
