Soundoff Signal P Serie Instrucciones De Montaje página 7

P SERIES 6X4 WARNING LIGHT
REMOTE MODE: FOR USE WITH bluePRINT® SYSTEM ONLY
Connecting the Green wire to ground before applying power to the Red or Orange wires will place the LED module into remote mode and the light output color will be directly controlled by the input wires as shown below.
For Cruise mode or Low Power control of the LED module, the signal to the control wires must be 100 +/- 2Hz using the duty cycle inputs listed below to produce the light output.
mpower® 7x3 LED Light Remote Mode Functionality
Red Wire Orange Wire
Cruise
- Cruise
Cruise Cruise
Flash
- Flash
Flash Flash
Steady ON
- Steady ON
Steady ON Steady ON
Cruise Flash
Cruise Steady ON
Flash Steady ON
1.800.338.7337 / www.soundoffsignal.com
7
WIRING AND TABLE INFORMATION (CONT.)
Single Color
Color Swap=OFF Color Swap=ON
- Cruise Color 1
- Flash Color 1
- Steady ON Color 1
Dual Color
Color Swap=OFF Color Swap=ON
Cruise Color 1 Cruise Color 2
Cruise Color 2 Cruise Color 1
Cruise Color 2 Cruise Color 1
Flash Color 1 Flash Color 2
Flash Color 2 Flash Color 1
Flash Color 2 Flash Color 1
Steady ON Color 2
Steady ON Color 1
Steady ON Color 1
Steady ON Color 2
Steady ON Color 2 Steady ON Color 1
Flash Color 2/Cruise Flash Color 1/Cruise
Color 1 during OFF Color 2 during OFF
cycle of Flash cycle of Flash
Steady ON Color 2 Steady ON Color 1
Steady ON Color 1
Steady ON Color 2
Cruise Mode Duty Cycle
(@ 100Hz)
Input Light Output
40% OFF
50% 5%
60% 10%
Low Power Flash D.C.
(@ 100Hz)
Input Light Output
70% 30%
80% 40%
90% 50%
6X4 POLYCARB_WARNING 0422 REV C