Idiomas disponibles
Idiomas disponibles
P SERIES 6X4 WARNING LIGHT
FIG. 1
BEZEL
SCREWS
1.800.338.7337 / www.soundoffsignal.com
1.800.338.7337 / www.soundoffsignal.com
2
2
GASKET
6X4 SCREW MOUNT BACKUP LIGHT SHOWN
WIRE HARNESS
WIRE HOLE
WELL NUTS
SCREW MOUNT INSTALLATION
1. Drill (4) 5/16" holes to mount light. Drill 3/4" wire hole.
See Fig. 2
2. Insert the well nuts into the 4 drilled holes. Fully seat to
mounting surface.
3. Align the gasket to the mounting surface.
NOTE: Horizontal and vertical orientations indicated
on gasket for proper seal.
4. Pull the wire harness through the opening and plug into
the back of the light.
5. Place the light into the gasket, pressing light, and gasket
against mounting surface.
6. Place bezel over the light and gasket.
7. Secure the light to mounting surface using (4) supplied
screws tightened to 15 inch lbs.
NOTE: Tighten until gasket is compressed.
DO NOT over tighten the well nuts.
DO NOT USE POWER
TOOLS TO TIGHTEN
6X4 POLYCARB_WARNING 0422 REV C
6X4 POLYCARB_WARNING 0422 REV C
