Idiomas disponibles
Idiomas disponibles
• Place the popcorn maker on a level surface.
• Before first use, it is recommended to wipe the popcorn maker and accessories with a
damp cloth.
• Measure the corn using the top cover as a measuring cup. One full measure per session
is enough. More than one full measure could overfill the popcorn maker and disturb the
proper functioning of the machine.
• Preheating of the appliance is not necessary.
• Do not add any other ingredients during popping such as: oil, shortening, butter, margarine,
salt or sugar, as damage will occur.
• Pour the popcorn into the aluminum heat chamber through the corn inlet.
• Replace the top cover before starting making popcorn.
• Place a large bowl under the spout so that the edge of the bowl is touching the body of the
popcorn maker. It is important that the popcorn ejects down the spout into a bowl and it is
not re-directed, blocked or otherwise interfered with, since the popcorn is hot and prema-
ture contact may cause minor discomfort.
• Switch on the popcorn maker. After a few moments the continuous popping action will
automatically feed popcorn from the aluminum heat chamber out through the spout until
all has popped. This process will last about 3 minutes.
• Turn off the popcorn maker and remove the mains plug from the mains supply when pop-
ping has stopped.
• If more popcorn is required, remove the popcorn remaining in the aluminum heat chamber.
Pay attention not to get burnt when handling the top cover as this part is very hot when the
popcorn maker is functioning.
NOTE : Wait for approx. 10 to 12 minutes before using the popcorn maker again.
WARNING: Do not add oil. Please use dry corns for popping. Place the top cover in its posi-
tion. Never put butter into the aluminum heat chamber.
• Before cleaning, remove the mains plug from the mains supply.
• Make sure the popcorn maker has cooled down completely before cleaning.
• Clean the plastic parts of the popcorn maker with a damp cloth. Never use abrasive prod-
ucts as they could damage the popcorn maker.
• The top cover can be cleaned in warm soapy water.
• When the popcorn maker is not in use, disconnect and store it in a safe, dry place, out of
reach of children.
In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous substances in elec-
tric and electronic equipment as well as their waste disposal. The symbol with the crossed dustbin shown on the package
indicates that the product at the end of its service life shall be collected as separate waste. Therefore, any products that
have reached the end of their useful life must be given to waste disposal centres specialising in separate collection of
waste electrical and electronic equipment, or given back to the retailer at the time of purchasing new similar equipment,
on a one for one basis. The adequate separate collection for the subsequent start-up of the equipment sent to be recycled,
treated and disposed of in an environmentally compatible way contributes to preventing possible negative effects on the
environment and health and optimises the recycling and reuse of components making up the apparatus. Abusive disposal
of the product by the user involves application of the administrative sanctions according to the laws.
8
E NGL I SH
OPERATING INSTRUCTIONS
CLEANING AND STORAGE
