disappear, while the engine will run at high speed. This is a sign that the tank is full
of water and the device should be turned off immediately and the tank emptied.
3.4.
Cleaning and maintenance
a)
Before any cleaning, adjustment, or replacement of accessories, and if the
device is not in use, pull the mains plug.
b)
Use only non-corrosive cleaning agents for cleaning surfaces.
c)
After each cleaning, the components in question should be dried well before
the device is used again, especially this applies to the transition from wet
vacuuming to dry vacuuming.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Use a soft, damp cloth for cleaning.
h)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as they may damage the surface of the appliance material.
i)
Do not clean the device with acidic substances, medical products, thinners,
fuel, oil, or other chemicals as this may damage the device.
j)
The sponge filter should be removed and rinsed in warm water with a mild
detergent, if necessary, after using the device and dried completely before
using it again. Replace the filter with a new one if the filter is heavily worn or
if there is a noticeable decrease in the performance of the device.
DISPOSAL OF WASTE APPLIANCES
At the end of its useful life, this product should not be disposed of with normal
household waste but should be taken to a collection point for the recycling of
electrical and electronic equipment. This is indicated by the symbol on the
product, operating instructions, or packaging. The materials used in this appliance
are recyclable according to their marking. By reusing, recycling, or applying other
forms of use of waste machines, you make a significant contribution to the
protection of our environment.
Your local administration will provide you with information about the appropriate
disposal point for used appliances.
3.5 Troubleshooting
Problem
Dust or liquid
comes out of the
Possible cause
1. Accessories not
tightly connected.
Action
1. Improve the
accuracy of