Guidance And Manufacturer's Declaration - Electromagnetic Immunity - Handicare SystemRoMedic EvaDrive Manual De Usuario

Guidance and manufacturer's declaration – electromagnetic immunity
The EvaDrive is intended for use in the electromagnetic environment specified below. The customer or
the user of the EvaDrive should assure that it is used in such an environment.
Immunity test
Conducted RF 3 Vrms
IEC 61000-4-6 150 kHz to 80 MHz
Radiated RF 3 V/m
IEC 61000-4-3 80MHz to 2,5GHz
EN-ISO
10 V/m
10535:2006
800MHz to 2GHz
EN 61000-4-3: Extended the frequency range 2,5
GHz – 2,7 GHz.
EN 61000-4-3: Extended test level of 10 V/m for
frequency range 1,0 GHz – 2,0 GHz.
EN 61000-4-8: Extended test level of 30 A/m.
NOTE 1 At 80MHz and 800MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflected from structures, objects and people.
a
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones
and land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be
predicted theoretically with accuracy. To assess the electromagnetic environment due to fixed RF
transmitters, an electromagnetic site survey should be considered. If the measured field strength in the
location in which the EvaDrive is used exceeds the applicable RF compliance level above, the
EVADRIVE should be observed to verify normal operation. If abnormal performance is observed,
additional measures may be necessary, such as reorienting or relocating the EvaDrive.
b
Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 10 V/m.
128
IEC 60601 test Compliance
level
3 Vrms
3 V/m
10 V/m
Electromagnetic environment - guidance
level
Portable and mobile RF communications
equipment should be used no closer to any part
of the EvaDrive, including cables, than the
recommended separation distance calculated
from the equation applicable to the frequency of
the transmitter.
Recommended separation distance
d 1 2 , P
=
d 1 2 , P
=
d = 2 3 , P
where P is the maximum output power rating of
the transmitter in watts (W) according to the
transmitter manufacturer and d is the
recommended separation distance in meters
(m).
Field strengths from fixed RF transmitters, as
determined by an electromagnetic site survey,
should be less than the compliance level in
each frequency range.
Interference may occur in the vicinity of
equipment marked with the following symbol.
I N S T R U C T I O N S F O R U S E SystemRoMedic
80 MHz to 800 MHz
800 MHz to 2,5 GHz
b
a
TM