Stihl FS 100 RX Manual De Instrucciones página 9

Ocultar thumbs Ver también para FS 100 RX:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

English / USA
Catalytic converter
!
Warning!
Some STIHL trimmer
models are equipped with
a catalytic converter,
which is designed to
reduce the exhaust
emissions of the engine
by a chemical process in the muffler.
Due to this process, the muffler does not
cool down as rapidly as conventional
mufflers when the engine returns to idle
or is shut off. To reduce the risk of fire
and burn injuries, the following specific
safety precautions must be observed.
!
Warning!
Since a muffler with a catalytic converter
cools down less rapidly than conven-
tional mufflers, always set your trimmer
down in the upright position and never
locate it where the muffler is near dry
brush, grass, wood chips or other
combustible materials while it is still hot.
8
Let the engine cool down sitting on
concrete, metal, bare ground or solid
wood (e.g. the trunk of a felled tree)
away from any combustible substances.
!
Warning!
To reduce the risk of fire or burn injury,
let the unit cool down before refueling
your trimmer after use.
!
Warning!
Never disassemble or modify your
muffler. The muffler could be damaged
and cause an increase in heat radiation
or sparks, thereby increasing the risk of
fire or burn injury. You may also
permanently damage the engine. Have
your muffler serviced and repaired by
your STIHL Servicing Dealer only.
!
Warning!
To reduce the risk of fire or burn injury,
keep the area around the muffler clean.
Remove all debris such as pine needles,
branches or leaves.
!
Warning!
An improperly mounted or damaged
cylinder housing or a damaged/
deformed muffler shell may interfere
with the cooling effect of the catalytic
converter. To reduce the risk of fire or
burn injury, do not continue work with a
damaged or improperly mounted
cylinder housing or a damaged/
deformed muffler shell. Your catalytic
converter is furnished with screens
designed to reduce the risk of fire from
the emission of hot particles. Due to the
heat from the catalytic reaction, these
screens will normally stay clean and
need no service or maintenance. If you
experience loss of performance and you
suspect a clogged screen, have your
muffler maintained by a STIHL Servicing
Dealer.
Working Conditions
Operate and start your trimmer only
outdoors in a ventilated area. Operate
the trimmer under good visibility and
daylight conditions only. Work carefully.
FS 100 RX

Capítulos

Tabla de contenido
loading

Tabla de contenido