Ryobi GD200 Manual Del Operador página 46

PROGRAMMING THE CAR REMOTES
See Figure 81.
WARNING:
Keep moving door in sight when using car remotes.
Contact with moving door can cause DEATH or serious
injury.
Once you begin programming the car remotes, you have two
minutes to complete each step. If a step is not completed
within two minutes, programming information will be erased.
 Press the PROGRAM button on the garage door opener's
console.
 The main garage door opener's LEDs will turn off and the
PROGRAM button will flash three times.
 Select button 1 or 2 on the car remote. Press the button
once.
 The car remote's green LED will flash.
 The PROGRAM button on the main unit will flash three
times.
 The garage door opener main unit LEDs will turn on.
 To verify that the program is set, press the car remote
button you selected earlier.
 The garage door will open or close.
 Repeat this process to sync the garage door opener with
an additional remote.
NOTE: Buttons 1 and 2 cannot both be programmed to the
same garage door opener.
NOTE: Safety sensors must always be connected properly
for the door to operate from the car remote.
NOTE: The garage door opener cannot be operated with a
car remote until travel limits have been set.
USING THE SMARTPHONE APP
See Figure 82.
WARNING:
To reduce the risk of injury to persons – Only enable the
RYOBI Garage Door Opener Module System App feature
when installed with a sectional door.
WARNING:
Devices or features, such as the RYOBI Garage Door
Opener Module System App, that allow you to open and
close the garage without the garage door being in view
should only be used with sectional garage doors.
OPERATION
 Download the RYOBI Garage Door Opener Module Sys-
tem App from the App Store or Google Play Store.
 Follow the instructions provided in the app and app guide
to control your garage door opener and modules. For more information, visit www.ryobitools.com.
46 - English
Visor
Clip
Buttons
8:08 AM 100%
Car
Remote
Fig. 81
Fig. 82