Idiomas disponibles
Idiomas disponibles
Before you start
Assembly
Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
Loop handle version
Loop handle assembly
U-handle version
U-handle assembly
WARNING
Assemble loop handle (A) and bracket (C) to drive shaft assem-
bly.
Position handle in comfortable operating position and tighten
Bolts (B).
E: Arrow
Install the handle to the engine side from the arrow
mark.
1.
Install handle assembling bracket (upper) (A) in handle as-
sembling bracket (lower) (B) and fix handle by tightening
handle assembling bolt (C) lightly.
2.
Adjust inclination of handle to adequate position (easy to op-
erate) and tighten firmly handle assembling bolt.
To adjust the fixture bolt (D) proceed (As needed)
(1) Tighten the bolts until snug.
(2) Loosen the bolts 1
E: Arrow
F: To engine
Install the handle to the engine side from the arrow
mark.
3.
To eliminate loosening of throttle wire (I), fix it to shaft tube
(H) (2 places) and to right hand U-handle (1 place) with wire
fixing clips (G).
10
F: To engine
CAUTION
1
/
turn.
2
CAUTION
