Idiomas disponibles
Idiomas disponibles
When bevelling or deburring, the device must always be guided from left to right (up-cut
milling).
Operation with the device in all positions must be carried out with both hands.
Switching Off
1. Withdraw device from material.
2. Operate ON/OFF switch, the motor is turned off.
Attention:
Perform regular wear checks on cutting inserts. Sharp cutting inserts ensure efficient cutting performance
and prevent device from damage. Ensure to rotate or replace blunt or cracked cutting inserts when due.
Maintenance Intervals
Transmission and gearhead:
Recommended grease:
Mounting thread on
transmission housing:
Motor air vents:
Cutting inserts:
Ball bearing race:
Tool change:
Changing the Cutting Head
1)
Loosen knurled screw and remove support plate with adjusting collar.
2)
Press release button and engage drive shaft.
3)
Loosen cutting head counter clockwise with hook wrench (supplied).
1 = Support plate with
adjusting collar.
Lubrication carried out by a specialist at every 100 operating hours or
replace lubricating grease.
Grease off the type MSN 2 (Rhenus Norlith)
The first gear chamber needs to be filled up with 20 g
and the gear chamber on the motor side with 17 g.
Clean and lubricate as necessary.
Clean as necessary.
Rotate or replace as necessary.
Replace as necessary.
Push the shaft lock on the motor to the side and rotate milling head
counter-clockwise. Completely remove cutting insert holder.
1 = Release button.
2 = Drive shaft.
14
