Correct Usage - Toshiba RAV-SM564UT-E Manual Del Propietário

4-way Air Discharge Cassette Type
4

CORRECT USAGE

• When you use the air conditioner for the first time or when you change the SET DATA value, follow the
procedure below. From the next time, the operation displayed on the remote controller will start by
pushing the
Preparation
Turn on the main power switch and/or the leakage breaker.
• When the power supply is turned on, a partition line is displayed on the display part of the remote
controller.
* After the power supply is turned on, the remote controller does not accept an operation for approx.
1 minute, but it is not a failure.
REQUIREMENT
• While using the air conditioner, operate it only with
switch and the leak breaker.
• When you use the air conditioner after it has not been used for a long period, turn on the leakage
breaker at least 12 hours before starting operation.
TEMP.
4
FILTER
RESET TEST
Start
1
Push
The operation lamp goes on, and the
operation starts.
2
Select an operation mode with the
"MODE
One push of the button, and the display
changes in the order shown as follows.
AUTO HEAT
button only.
ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
SET CL SWING/FIX UNIT LOUVER
button.
" button.
DRY COOL
button without turning off the main power
3
Select air volume with "
One push of the button, and the display
changes in the order shown as follows.
AUTO
1
• When air volume is "
3
volume differs according to the room
2
temperature.
• In heating operation, if the room
temperature is not heated sufficiently with
VOLUME "
" MED." or "
• The temperature sensor senses
temperature near the suction air port of the
indoor unit, which differs from the room
temperature depending on the installation
condition.
A value of setting temperature is the
measure of room temperature.
("AUTO
mode.)
4
Determine the set up temperature by
pushing the "TEMP.
FAN
" button.
Stop
Push
The operation lamp goes off, and the operation
stops.
In the COOL, DRY, or AUTO (cooling) mode, the
fan runs for 10 minutes (or more) for self cleaning.
– 8 –
Owner's Manual
" button.
HIGH MED.
AUTO", air
LOW" operation, select
HIGH" operation.
" is not selectable in the FAN
" or "TEMP.
button.
EN
LOW
8-EN