Hilti SID 2-A Manual De Instrucciones Original página 13

5 Operation
5.1 Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery
and the contacts on the product are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible
click.
3. Check that the battery is seated securely.
5.2 Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out of its holder in the device.
5.3 Charging the battery
1. Before charging the battery, read the operating instructions for the
charger.
2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery.
5.4 Switching on
▶ Press the control switch.
➥ Speed of rotation is regulated by the distance the control switch is
pressed in.
5.5 Switching off
▶ Release the control switch.
5.6 Setting forward or reverse rotation
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the
middle position (safety lock).
▶ Set the forward/reverse switch to the desired direction of rotation.
5.7 Fitting an accessory tool
1. Set the forward/reverse switch to the middle position or remove the
battery from the tool.
*2081237*
Printed: 11.07.2019 | Doc-Nr: PUB / 5206157 / 000 / 04
3
2081237
2
English 9