RIB DUKE B2D 24V-CRX Manual De Instalación página 41

Ocultar thumbs

página de 74

/ 74

Idiomas disponibles

EVENT

Dip 1 ON (hold-to-run mode)

Or failure of a safety device

Dip 2 ON (full stroke programming)

Dip 2>1 ON (pedestrian stroke programming)

Programming sequence stopped due to intervention of a safety

device

EVENT

No transmitter code entered

Dip 1 > 2 - transmitter code programming for full opening

Dip 1 > 3 - transmitter code programming for pedestrian

opening

Dip 1>2> 3 - transmitter code programming for R-AUX relay

Correct transmitter codes programming for full opening and

R-AUX relay

Correct transmitter codes programming for pedestrian opening

Remote control code not present in memory

Memory saturated by remote control codes (1000 codes saved)

Radio code deletion for full opening, pedestrian opening, R-AUX

relay

EVENT

Stop button pressed

Photocell intervention

Edge intervention

Intervention of impact sensor

Failure of a safety device or safety device engaged for too long

Running with emergency batteries (24 vdc)

Emergency batteries low signal

Operation with emergency batteries charged by solar panels

Alarm from edge

Impact sensor alarm

Failed photocells auto-test alarm

Functional block activated by smartphone

Achievement of set cycles

Energy saving activated by smartphone

TROUBLE SHOOTING

After having carried out all connections, by carefully following the layout and having positioned the gate in intermediate position, check the correct ignition of red LEDS DL6, DL7, DL8, DL9

and DL10.

In case of no ignition of the LEDS, always with gate in intermediate position, check the following and replace any faulty components.

DL6

OFF

Stop button malfunction (if Stop is not connected, perform the jump between COM A+ and STOP).

DL7 or DL8

OFF

Faulty photocells (In case the edge is not connected, carry out jumper between COM A+ and PHOTO 1/PHOTO 2)

DL9 or DL10

OFF

Faulty safety edge (In case the edge is not connected, carry out jumper between COM A+ and EDGE 1/EDGE 2)

During functioning with personnel present, with DIP 1 at ON, check that during opening of M1 and M2 the green DL2 and DL4 LEDS switch on and that during closing of M1 and M2 the

red DL3 and DL5 LEDS switch on.

Or else, reverse the wires of the motor.

LED DL13 (BLUE)

Some functions are enabled via smartphone, so via smartphone check the card functions as the dips/trimmers status may not be true.

On the board there are resettable fuses which intervene in the event of a short circuit, interrupting the output assigned to them.

In the event of troubleshooting, it is advisable to disconnect all the removable connectors and insert them one at a time in order to more easily identify the cause of the fault.

TABLE SUMMARISING VISUAL AND SOUND ALARMS

SIGNALS DURING PROGRAMMING SEQUENCE

BUZZER STATUS

Off

10 seconds tone with 2 seconds pause

BUZZER STATUS

Off

1 Tone

Off

2 Tones

WARNING SIGNALS DURING OPERATION

BUZZER STATUS

Off

1 Tone

2 Tones

3 Tones

Off

1 Tone every 5 seconds for 1 minute