HTC 510 Manual Del Usuario página 13

5. Attach new diamond tools on the tool plate.
6. When the diamond tools are replaced, put the
product into operation position.
Introduction
WARNING Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
Daily maintenance
Daily maintenance means that you clean the product.
Also that you do a check of the electrical supply, the
brush strip and the grind holder.
1134 - 002 - 07.05.2019
To connect a dust extractor
Use a HTC dust extractor system.
1. Connect the dust extractor to the product. Use a 50
mm (2 inch) hose.
2. Make sure that the filters in the dust extractor are
clean and not damaged. Monitor the dust during the
operation.
Maintenance
To clean the product
• Always pull out the plug from the mains outlet before
you clean, do maintenance or assemble the product.
• Always clean all the equipment at the end of the
work day. Do not use a high pressure washer to
clean the product.
• Remove blockage from all air openings. The product
must always have sufficiently cool temperature.
To do a check of the electrical supply
CAUTION A blocked air intake decreases
the performance of the product and can
cause the motor to become too hot.
WARNING Do not use damaged cables. A
damaged cable can cause serious injury or
death.
13