Makita DML809 Manual De Instrucciones página 7

FCC Cautions to the user
For United States
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
The changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
The equipment has been tested and found to comply
with the limits for a Class B Digital Device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instruction, may cause harmful interference to radio
communication.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
ICES-005 standard For Canada
CAN ICES-005(B)/NMB-005(B)
USE PROPER EXTENSION CORD. Make sure your
extension cord is in good condition. When using an
extension cord, be sure to use one heavy enough to
carry the current your product will draw. An undersized
cord will cause a drop in line voltage resulting in loss of
power and overheating. Table 1 shows the correct size
to use depending on cord length and nameplate ampere
rating.
If in doubt, use the next heavier gage. The smaller the
gage number, the heavier the cord.
Ampere Rating
More Than Not More Than
0
6 10
10 12
12 16
Save all warnings and
instructions for future reference.
Table 1: Minimum gage for cord
Volts
120V
120V - 240V
6
Total length of cord in feet
25 ft. 50 ft.
50 ft. 100 ft.
AWG
18 16
18 16
16 16
14 12
7 English
100 ft. 150 ft.
200 ft. 300 ft.
16 14
14 12
14 12
Not Recommended