Idiomas disponibles
Idiomas disponibles
COMFORT - Tech
EN
Fiamma declines all liability for any personal injury or damage due to mounting or inability to use the product.
Product installation is to proceed according to the mounting instructions; the product may not be modifi ed or
altered in any way.
Mount the pump on a solid surface and in a position comfortable for fi lter cleaning and routine maintenance.
The pump can be installed in any position, in the event of installation in vertical position put the motor above
the hydraulic part.
Mount the pump near the water tank in order to obtain the best performance.
Despite the anti-vibration base kit is recommended to connect input and output of the pump through a min.
0.5mt. and diameter 1/2 "(13mm.) fl exible pipe in order to attenuate the vibrations that otherwise the pump
would send to the hydraulic system causing noise.
The installation of the Fiamma A20 expansion tank (02478-01-) within the fi rst meter of the implant optimizes
and stabilizes the performance of the product.
The pump is designed only for intermittent use and for contact with drinking water, any other use may cause
undesired operation.
For safety reasons, it is advisable to always disconnect the negative terminal from the batteries on the vehicle
and then work without power during installation.
It is suggested to connect the power cable to the fuse box or to the terminal board and not directly to the
battery.
Prepare for the electrical connection a dedicated circuit with a cable of 16AWG 1.5mm ² minimum section
protected by 7.5 A and 15 A switch located on the positive cable.
Installing an oversized fuse can cause overheating which can result in a short circuit or malfunction of the
entire electrical equipment.
Choose the safest and shortest installation for the power cable. Reduce the length of the power cable as
necessary.
Use only cable clamps suitable for the diameter of the power cable for connection to the terminal board.
If incorrect terminals are used, this could cause a voltage drop and increase the formation of heat on the
terminal.
When using for the fi rst time, it's advisable to proceed with the sanitation so as to remove any processing
waste.
Check periodically the cleaning of the inlet fi lter or in the event of low fl o.
Clean the fi lter periodically (at the start and end of the season)
During winter storage if outdoor temperatures are expected <0 ° C it is absolutely necessary to drain the entire
plumbing system, especially the pump by disconnecting the vacuum hose and making it run for a few minutes
as long as no water comes out from all the taps .
To ensure the proper operation of the pump and of the plumbing system is recommended to make the
sanitization of the same at least once a year or after a long period of non-use of the product.
Periodically check the tightness of the hydraulic components that vibrations may have loosened.
The manufacturer will not be held responsible for claims for damages resulting from the following:
- Defective installation or connection of the product.
- Damage to the product caused by mechanical infl uences and overvoltage.
- Alterations on the device without the express authorization of the manufacturer.
- Use of the product for other purposes not described in the operating manual.
7
