Warranty Information; Splasher 2 Year Manufacturer's Warranty; Warranty Exclusions - Astralpool SPLASHER Manual De Instrucciones

TROUBLESHOOTING
PROBLEM SOLUTION
• SPLASHER Adjust your pool's return flow / aimflow towards the problem area to guide the
is sticking on pool cleaner away from the steps.
stairs
Verify proper hose length and correct position of the Hose Weight(s).
Remove or add one hose section.
Using your flow control valve, increase or decrease the flow to your
SPLASHER within the maximum/minimum range.
• SPLASHER Ensure correct hose length. Change the hose length by adding or removing
is moving in a set sections of the hose.
pattern
Ensure that the hoses are in good condition. The hose should not be coiled
or bent. Always store hoses in straight position.
• Diaphragm For instructions on how to change your SPLASHER diaphragm, please see
Assembly the Maintenance section.
12

WARRANTY INFORMATION

SPLASHER 2 year Warranty
(Attach sales receipt as proof of purchase date)
Your new SPLASHER was carefully checked before shipment. Upon unpacking, if any parts are missing
or found to be defective notify your dealer immediately. Please consult owner's manual for instructions
on the installation and operation of this product. The Manufacturer warrants this SPLASHER to be free
from defects in materials and workmanship for a period of two (2) years from proven date of purchase.
If your SPLASHER has a defective part, please take the pool cleaner to the store where purchased to
have it repaired.

Warranty exclusions

This warranty excludes the following:
1. Discolouration of the SPLASHER is caused by reaction to chemicals used in the pool water.
Discolouration does not affect the operational ability of the SPLASHER. Therefore this warranty does
not cover the replacement of discoloured parts.
2. Damage to, or malfunction of the unit resulting from excess chlorinating or improper water chemistry
balance.
3. Replacement of parts that fail or become defective as a result of improper installation, negligence,
misuse, abuse or tampering by unauthorised repair personnel.
4. Age, pool water imbalance and improper installation can cause pool liners to become brittle or unduly
wrinkled. Corrosion of the supporting walls and/or irregularities in the pool base may also cause liner
failure. The use of this product in such an environment is at the pool owner's risk. Therefore the pool
owner hereby releases any and all claims for damage where these conditions exist.
5. Abrasion to the hose or damage caused by misuse or improper installation.
6. All wearing parts must be regularly checked and replaced when worn. These include the foot pad, disc
and bumper wheel.
7. All newly installed pools must be properly cured before a cleaner is used. Use of a cleaner can only
take place once the pool has cured.
8. A cleaner must be properly installed and its performance must be monitored to ensure no undue wear
and tear on product or pool occurs.
9. The Diaphragm is a wearing part which could be damaged by debris picked up from the pool floor,
under these circumstances it will NOT be covered by the m anufacturer's warranty.
Note: Most problems are caused by poor installation, poor water chemistry, wear and tear, twigs or debris
blocking the Diaphragm or low suction from a dirty filter. No claim under this warranty will be recognized
unless the attached registration card is completed and returned within fourteen (14) days of the day of
purchase. Only the original purchaser may claim under his warranty and SALES RECEIPT or PROOF
OF PURCHASE DATE is required. Purchaser's claims shall be limited to manufacturing defects only.
ENGLISH
13