Volpi Kamikaze PV295 Manual Del Usuario página 43

P. Press the plastic cap.
R. Screw the M5 socket screw as shown.
Screw the M5 hexagon socket countersunk
M.
head counterclockwise as shown.
15.4. Tool Calibration
If a replacement motor or drive plate is required, the pruners need to be recalibrated.
Follow next steps to perform the calibration:
1) Remove the upper and lower blades.
2) Insert the battery.
P
Q. Insert the ring nut.
R
S. Place the flat needle roller bearing and the
washer as shown and screw on the locking nut.
T
N. Reduce the friction between the two plans of
the blades by adding grease through the hole of
the plastic cap as shown in the figure.
Q
S
U
43