Idiomas disponibles
Idiomas disponibles
20
www.aeg.com
Problem
The temperature in the ap-
pliance is too low/too high.
DEMO appears on the dis-
play.
A
or
shown instead of numbers
on the temperature display.
If the advice does not lead
to the desired result, call the
nearest Authorized Service
Centre.
8.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Possible cause
The temperature is not set
correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The Frostmatic function is
switched on.
The Coolmatic function is
switched on.
There is no cold air circula-
tion in the appliance.
The appliance is in demon-
stration mode.
Temperature sensor prob-
or
symbol is
lem.
Solution
Set a higher/lower tempera-
ture.
Refer to "Closing the door"
section.
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Refer to "Frostmatic func-
tion" section.
Refer to "Coolmatic func-
tion" section.
Make sure that there is cold
air circulation in the appli-
ance. Refer to "Hints and
Tips" chapter.
Keep the OK key pressed for
approximately 10 seconds
until a long sound is heard
and the display turns off for
a short time.
Contact the nearest Author-
ized Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
installation instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
