Door Position Adjustment; Installing The Faucet - Conglom QL101 Manual Del Usuario

Installation (continued)

DOOR POSITION ADJUSTMENT

If the doors need to be repositioned, the hinges can be adjusted to
ensure a precise fit with the cabinet.
1 . The lateral adjustment screw adjusts the door orientation from
left to right .
2 . The horizontal adjustment screw adjusts the door orientation
from front to back .
3 . The vertical adjustment screw adjusts the orientation
up or down .

INSTALLING THE FAUCET

- Connect the spray head to the hose .
- Remove the gasket, metal washer, and retaining nut from the faucet .
- Install the faucet through the hole in the sink .
- From underneath, secure the faucet to the sink with the gasket,
metal washer, and retaining nut .
- Tighten the retaining nut by hand until it is snug . Use a wrench to
tighten it down . Gently tighten the two screws on the retaining nut . Do not over tighten .
- Hand-tighten the hose to the faucet outlet. Tighten the fittings using
two wrenches . Hold the faucet outlet steady with a wrench while
turning the hose fitting with another wrench until it is snug.
NOTE:
Failing to use two wrenches can damage the faucet. Do not
overtighten.
- Push the spray head into the faucet neck . Install the counterweight
a couple of inches from the bottom of the hose on the side closest to
the spray head . There should be no slack in the hose and it should
retract freely .
- Connect the water supply lines (not supplied) to the faucet .
Faucet body
Gasket
Retaining nut
Faucet outlet
7
Please contact [email protected] or 1-877-333-0098 for further assistance .
1
3
Faucet
neck
Spray
head
Sink
Metal Washer
Screws
Faucet
outlet
Hose
Counterweight
Hose
CONGLOMKB .COM
2