Idiomas disponibles
Idiomas disponibles
Under any circumstances, make sure the hob is well ventilated and the air inlet
Under any circumstances, make sure the hob is well ventilated and the air inlet
and outlet are not blocked. Ensure the hob is in good work state. As shown below
and outlet are not blocked. Ensure the hob is in good work state. As shown below
Note: The safety distance between the hotplate and the cupboard
Note: The safety distance between the hotplate and the cupboard above the hotplate
should be at least 760mm.
A(mm)
B(mm)
760
50 min
Before you install the hob, make sure that
Before you install the hob, make sure that
•
The work surface is square and level, and no structural members interfere with
work surface is square and level, and no structural members interfere with
space requirements.
•
The work surface is made of a heat-resistant material
•
If the hob is installed above an oven, the oven has a built
the hob is installed above an oven, the oven has a built-in cooling fan.
•
The installation will comply with all clearance requirements and applicable
standards and regulations.
•
A suitable isolating switch providing full disconnection from the mains power
suitable isolating switch providing full disconnection from the mains power
supply is incorporated in the permanent wiring
with the local wiring rules and regulations.
•
The isolating switch must be of an approved type and provide a 3
contact separation in all poles (or in all active [phase] conductors if the local wiring
contact separation in all poles (or in all active [phase] conductors if the local wiring
rules allow for this variation of the requirements).
rules allow for this variation of the requirements)
•
the isolating switch will be easily accessible to the customer with the hob installed
•
you consult local building authorities and by
you consult local building authorities and by-laws if in doubt regarding installation
You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall
•
surfaces surrounding the hob.
When you have installed the hob, make sure that
When you have installed the hob, make sure that
•
The power supply cable is not accessible through cupboard doors or drawers
he power supply cable is not accessible through cupboard doors or drawers.
•
There is adequate flow of air from outside the cabinetry to the base of the hob
•
If the hob is installed above a drawer or cupboard space, a thermal protection
f the hob is installed above a drawer or cupboard space, a thermal protection
barrier is installed below the base of the hob
barrier is installed below the base of the hob.
•
The isolating switch is easily accessible by the customer
he isolating switch is easily accessible by the customer.
C(mm)
20 min
with all clearance requirements and applicable
les and regulations.
n approved type and provide a 3mm air gap
ch will be easily accessible to the customer with the hob installed
flow of air from outside the cabinetry to the base of the hob.
D
Air intake
resistant material.
wiring mounted and positioned to comply
clean finishes (such as ceramic tiles) for the wall
21
21
E
Air exit 5mm
