Idiomas disponibles
Idiomas disponibles
BASIC SET-UP
SHREDDER SET-UP
1
2
Ensure access
Make sure safety
to a dedicated
flap is securely
20Amp, 120V
in place
outlet
OILING SET-UP
1
2
Remove oil bottle
Hook oil
holder from
bottle holder
cabinet
into side of
cabinet
SHEET CAPACITY GAUGE
Eliminates frustrating jams by preventing overloads.
TROUBLESHOOTING AND PREVENTIVE MAINTENANCE
• Empty wastebasket when bin full indicator lights up.
• Shredder won't run if the door is open, or bin needs to be emptied.
• Maintenance is an important part of protecting your investment. Don't forget to purchase our oil (3505801) and shredder bags (3604101).
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
PAPER JAM
Set to Off ( ) and empty bin. Replace bin and follow the below
procedures.
1
2
Gently pull uncut
Stops automatically
paper from
if too much paper
paper entry.
is inserted.
Machine runs for
Automatic reverse
a short time in
if paper jams
reverse. Repeat if
necessary
BASIC SHREDDING OPERATION
PAPER
1
Press ( ) ON to
Plug in and make
activate
sure door is closed
3
4
Put oil tube into oil
Remove lid
bottle and screw
from oil bottle
stopper on
Electronically measures paper thickness to prevent
paper jams:
Up to RED: Too many sheets have been
inserted. Automatic reverse of paper.
Up to YELLOW: Maximum sheet capacity.
Up to GREEN: Normal sheet capacity
during shredding process.
LIMPIEZA DE LOS SENSORES INFRARROJOS DE INICIO AUTOMÁTICO
CLEANING AUTO-START INFARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on
rare occasions the sensors may become blocked by paper dust causing the motor to
run even if there is no paper present
of the paper entry).
3
TO CLEAN THE SENSORS
1
Shred One Sheet
Turn off and
unplug shredder
2
3
Feed paper
straight into paper
entry and release
5
6
Place oil bottle
Close door. Plug
into oil holder on
into socket-outlet
side if cabinet
SLEEP MODE
WHEN IN SLEEP MODE
1
In sleep mode
2
Locate Auto-start
infared sensor
4
5
or
When finished
Do nothing and
shredding set to
shredder will go
( ) OFF
automatically to
sleep mode after
1 hour
7
8
Oil pump starts
After changing oil
automatically on
bottle, press Reverse
first use. To stop Oil
(R) until Oil Indicator
Indicator ( ) from
( ) no longer
blinking red, press
blinks red
ON ( ) after 15
seconds
2
3
To get out of sleep
or
insert paper
press ON ( )
(Note: two paper detection sensors are located in the center
3
4
Use thin, long-handled
Clean any
brush to clean sensors.
contamination from
Make sure brush is
the paper sensors
clean and dry
3
