Installing Dust Control Bag; Adjusting The Control Grip Height; Machine Operation; Pre--Operation Checks - Nobles SpeedGleam Manual Del Operador

INSTALLING DUST CONTROL BAG

1. Open the dust control bag compartment at the
front of the machine.
2. Slide the bag over the plastic snout. Close
compartment (Figure 7).
3. Empty or replace the dust bag daily. Do not allow
bag to fill beyond half full.

ADJUSTING THE CONTROL GRIP HEIGHT

The machine has three control grip height settings.
1. Locate the two spring loaded levers below the
console (Figure 8).
2. Squeeze the levers together and lift or lower
control grips to a comfortable operating height
(Figure 8).
Nobles SpeedGleam/Plus (01- -05)
FIG. 7
FIG. 8

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
WARNING: Fire Or Explosion Hazard. Never
Use Flammable Liquids Or Operate Machine in Or
Near Flammable Liquids, Vapors Or Combustible
Dusts.
PRE- -OPERATION CHECKS
1. Sweep floor and remove debris.
2. Check condition of pad.
3. Check battery charge level (For accurate reading
pad must be spinning). Batteries will need
recharging if battery meter reads in the yellow or
red zone.
4. Check that the dust control bag is installed.
5. Make sure the floor is completely dry.

BURNISHING WITH THE PUSH MODEL

1. Turn key on, if equipped, then turn the main power
to the ON position (Figure 9).
2. Pull the trigger switches to start the pad spinning.
The pad will automatically draw to floor
(Figure 10).
FIG. 10
OPERATION
FIG. 9
9