2
INSTALL MOWER AND DRIVE BELT
Eng
Be sure tractor is on level surface and mower suspension
arms are raised with attachment lift lever. Engage parking
brake.
•
Cut and remove tie from anti-sway(1) bar. Swing bar to
left side of mower.
•
Slide mower under tractor.
IMPORTANT: CHECK BELT FOR PROPER ROUTING IN
ALL MOWER PULLEY GROOVES. INSTALL BELT INTO
ELECTRIC CLUTCH PULLEY GROOVE(2).
•
Install one front link(3) in top hole of the R.H. front mower
bracket(7) and R.H. front chassis bracket(6). Retain with
two single loop retainers(A).
•
Install second front link(3) in L.H. front chassis bracket(5)
and retain with single loop retainer(A).
•
Turn height adjustment knob counterclockwise until it
stops.
•
Lower mower linkage with attachment lift lever.
•
Place L.H. suspension arm(8A) on outward pointing
pins(9).
•
Slide left side of mower back and install the unattached
front link(3) in top hole of L.H. front mower bracket(4).
Retain with single loop retainer(A).
•
Place R.H. suspension arm(8B) on outward pointing
pins(9).
•
Connect anti-sway bar(1) to chassis(10) under left foot-
rest and retain with double loop retainer(B).
11
B
A
9
10
1
11
22
•
Retain both suspension arms to deck pins(9) with double
loop retainers(B).
•
Turn height adjustment knob clockwise to remove slack
from mower suspension.
•
Raise deck to highest position.
•
Assemble gauge wheels(11) as shown . Tighten se-
curely.
1. Anti-sway bar
2. Clutch pulley
3. Front links
4. L.H. front mower bracket
5. L.H. front chassis bracket
6. R.H. front chassis bracket
7. R.H. front mower bracket
8A. L.H. Suspension arm
8B. R.H. Suspension arm
9. Outward pointing pins
10. Chassis bracket
11. Gauge wheels
A. Single loop retainer
B. Double loop retainer
5
8A
8B
3
4
2
6
3
7