Idiomas disponibles
Idiomas disponibles
HO 181 IA
ATTENTION: This symbol show: Hot surface. The temperature of the door or the outer surface may be
high when the appliance is operating.
INSTALLATION
• After removing the packing materials, check the integrity of the appliance; if you are unsure, do not use it and
ask for qualified professional help. The packing materials (plastic bags, polystyrene foam, nails, etc.) must be
kept out the reach of children because they are potential sources of danger; dispose of them according to
current regulations, in dedicated containers for differentiated collection. Attention: any stickers or advertising
material applied to the door must be removed before using the appliance. The manufacturer declines all
responsibility in case this is not safe working practices will be respected.
• Before connecting the appliance, check that the voltage shown on the data plate matches that of your power
supply and that the electric plug is grounded. In the event of incompatibility between the electric outlet and
the plug of the appliance, have the outlet replaced with another more suitable type by professionally qualified
personnel, who will make sure that the section of the wires of the outlet is appropriate for the absorbed power
of the appliance. In general, the use of adapters or extension cords is not recommended; if their use is
indispensable, they must conform to existing safety standards and their current capacity (amperes) must not
be less than the maximum of the appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Each time before use, check that the appliance is in good condition and that the electric cord is not damaged:
if in doubt, ask for professionally qualified help.
• Make sure that the cable is correctly positioned, that it is not touching hot elements or sharp edges, is not
wound around the utensil, is not twisted up on itself or in the way, so the appliance cannot tip over.
• Place the appliance:
- Far from other sources of heat (for example, other ovens, gas hobs, etc.), inflammable materials (wallpaper,
etc.), explosive materials (spray cans) and materials that would become deformed when heated.
- On a flat and stable work top and not on delicate surfaces (painted furniture, tablecloths, etc.), in a position
where it cannot be bumped, and at a suitable distance from the edge so that it cannot fall.
- Far from containers of liquids, such as sinks, etc. Should it unexpectedly become wet or fall in a liquid, remove
the plug immediately from the socket, leave the appliance to cool, dry carefully and make sure the electric
parts are not wet; if in doubt, call qualified professional help.
• This oven has not been designed to be built-in. Place the unit on a dry and smooth surface and make sure
that the oven is a minimum 20 cm away from the wall at both sides and 50cm at the upper part . The back
should be placed against a wall. Do not place it close to a closet. Make sure the door can be completely open
without resistance.
• The bread may burn, always check the oven during roasting or grilling.
• If any part of the product should catch fire, do not attempt to extinguish with water. Smother flames with a
damp cloth.
• Be careful not to obstruct the air vents. Obstruction of the grids could cause the appliance to overheat.
• The appliance must not be positioned immediately under a socket.
• Do not use the appliance with a timer or a programmer or with a system that can switch on the appliance
automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or positioned incorrectly.
• In the case of a breakdown or fault, switch off the appliance and have it checked by a professionally qualified
technician; repairs made by unqualified persons can be dangerous and render void the warranty.
8
