Profi Care PC-VL 3111 LB Manual De Instrucciones página 55

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
NOTE:
The end of the tube with the tank cap must be posi-
tioned at the front above the humidifier.
17. Insert the tube from the back to the front through the
opening on the top of the switch housing.
18. Pull the tube tight so that it lies flat against the back of
the switch housing.
NOTE:
The two ends of the tube should have approximately
the same length.
19. Connect the top end of the tube to the tube connector on
the protection grid (22).
NOTE:
The tube above the switch housing must not "sag".
Water which accumulates in the tube prevents the
formation of the mist. If necessary, push back the top
section of the tube.
20. Place the water tank (9) onto the base of the humidifier
(10).
21. Fit the tank cap on the bottom end of the tube onto the
water tank. The recess on the tank cap must fit into the
groove on the opening to the water tank.
NOTE:
• The tank cap on the end of the tube can be turned.
• The water tank must be fitted securely to the base
so that mist cannot escape between the water tank
and the base. If necessary tighten the lower section
of the tube.
Operation
Fill with Water
CAUTION:
Do not fill the water tank with water from clothes dryers
and water with additives (such as scented oils, perfume,
softeners, or other chemicals). Doing so may damage the
appliance.
NOTE:
• Only use distilled or boiled, cold tap water without
additives.
• Replace the water every 3 days, even if it has not yet
been used.
• If the appliance has not used for long periods, remove
the water from the water tank and from the base of the
humidifier.
• Pull the end of the tube with the tank cap out of the water
tank.
• Lift the tank from the base of the humidifier and turn it
over. The filling hole is located on the bottom of the tank.
PC-VL3111LB_IM
• Turn the tank cap and fill the water up to ca. 1 centimetre
below the rim. The tank holds around 3 litres.
• Close the cap again and place the tank back onto the
base.
• Place the end of the tube with the tank cap onto the
water tank.
NOTE:
Take note of the recess on the tank cap (see assembly
instruction, item 21).
Basic Settings
Set the blower inclination angle before starting the appli-
ance. You can adjust the inclination angle by tipping the
blower casing with both hands.
NOTE:
• The inclination angle amounts to approx. 10 °.
• The tube above the switch housing must not "sag" due
to the inclination of the blower. Water which collects in
the tube prevents the formation of mist.
You can operate the appliance using the remote control as
well as the buttons on the switch housing. The functions are
identical.
NOTE:
The LED´s on the switch housing indicate the settings.
ON / OFF Switch ON / OFF
Use the ON / OFF button to switch the appliance on or off.
NOTE:
• When switching on for the first time after you have
connected the mains plug to the mains outlet, the fan
works in NOR (normal) mode with a low speed (LO).
• After switching off and on again using the ON / OFF
button, the appliance continues working in the last set
mode.
SPEED Speed
Press the SPEED button to select one of the three different
speeds:
• LO
low
• MI
medium
• HI
high
TIMER Timer
If you want the timer to switch the appliance off, press the
TIMER button.
NOTE:
Every press of the TIMER button increases the operating
time by 30 minutes.
Maximum shut-off time: 7.5 hours.
55
07.12.22
loading