Cleaning The Hepa Filter; General Maintenance - POLTI Forzaspira LECOLOGICO AQUA ALLERGY_NATURAL CARE Manual De Instrucciones

It easily removes dust, dandruff and textile
residues. It is useful for preventing allergies,
as the mechanical action of the roller with
bristles vacuums up animal hair.
The mini turbo brush also has a hard rubber
bristle attachment, useful on more difficult
dirt. To remove the bristle attachment, press
the two pivots found on the side of the brush
and then remove it (fig.15)
(don't use the bristle attachment on delicate
surfaces).
To clean the mini turbo brush, turn the nut
and remove the upper part of the mini turbo
brush, as shown in fig. 16. Clean the inside of
the brush and refit it by following these steps
in reverse.
Parquet brush (J)
The parquet brush is designed to clean
delicate surfaces; it has bristles and wheels in
specially selected material to avoid damaging
such surfaces.
Turbobrush (K)
only for model Forzaspira Lecologico Aqua
Allergy _Turbo Care
The turbo-brush, thanks to a turbine system,
increases effectiveness and efficiency when
vacuuming fabric surfaces.
To clean the Turbo Brush, remove the door
(Fig. 17) and clean the inside of the brush.
Close the brush following the procedure in
the reverse order.
Flexible suction lance (L)
only for model Forzaspira Lecologico Aqua
Allergy _Turbo Care
For access to the most hard to reach places
such as car interiors, radiators and window
and door frames.
AUTOMATIC CABLE WINDER
Before putting your vacuum cleaner away,
rewind the power cable by pressing the
button (2), as shown in fig.11, being careful to
accompany it during winding.
PARKING UNIT USE
The parking housing allows you to fasten the
tube with the universal brush or the Turbo
Brush to the appliance's body.
Reposition on the appliance body: make the
groove on the back of the brush slide into the
guide of the accessories holder on the
appliance (Fig.11).
CLEANING THE WATER FILTER
ASSEMBLY (16):
• Pull the nozzle (17c) until it comes off the
filter cage. Separate the cage body (17a)
from the cage cover (17).
• Remove the sponge filter (17b) from the
cage. If the filter is damaged, replace it.
Rinse all the components under running
water. Let the sponge filter dry before
putting it back into the appliance.
• Reassemble the filter assembly, repeating
the operations in the reverse order.
Note: Make sure that the filter nozzle (17c) is
correctly positioned, checking that the arrow
on the nozzle is aligned with the notch on the
bottom of the cage (17a) (Fig.11).
• If the filter needs replacing, always use an
original filter, available from Polti Technical
Service Centres.
• A cleaning brush (M) is supplied for easy
cleaning of the water container (6); it can
also be used to clean the appliance's hose
connections and the accessories inside.
NOTE: Do not use the brush for cleaning the
outside of the appliance

CLEANING THE HEPA FILTER (10)

Proceed as follows to clean filters:
• press the two levers on the filter cover (9a)
and pull off the filter cover (9) (fig.12).
• Rotate the filter retainer (10a) as shown in
fig.13 and remove the Hepa filter (10)
(fig.14);
• Rinse the filter in cold running water. Shake
it gently after washing to eliminate any
residual dirt and excess water.
NOTE: let the filter dry naturally, far away
from light and heat sources. You should
wait 24 hours before reassembling the filter
in the appliance.
• Replace the filter if it is torn.
• The filter should be cleaned every 4
months.
WARNING: do not clean filters with the brush,
as this could damage them, decreasing their
filtering capacity.
Do not use detergents, do not scrape filters,
and do not wash them in a dishwasher.

GENERAL MAINTENANCE

Ensure that the appliance is switched off and
disconnected from the mains.
To clean the outside of the appliance, only
use a damp cloth and tap water.
Do not use detergents of any type.
| 24 |