Cleaning Upholstery; Emptying And Cleaning The Dust Container - POLTI FORZASPIRA MC 330_TURBO Manual De Instrucciones

Maximum level.
4.5 To end suction, press the foot pedal or the
button on the handleagain.
5. CLEANING DELICATE FLOORS
5.1 Make sure that chapter 1 has been completed.
5.2 Connect the telescopic tube to the flexible
hose and the parquet brush to the telescopic
tube.
The length of the telescopic tube can be adju-
sted. Press the button to extend it or shorten
it at will.
5.3 Press the foot pedal.
start to operate at maximum power.
Adjust the suction power, as shown in Chapter
3. For this type of surface, we recommend the
Maximum level.
5.4 To end suction, press the foot pedal
the button on the handleagain.
6. CLEANING CARPETS AND RUGS
6.1 Make sure that chapter 1 has been completed.
6.2 Connect the telescopic tube to the flexible
hose and the turbo brush to the telescopic tu-
be.
The length of the telescopic tube can be adju-
sted. Press the button to extend it or shorten
it at will.
The turbo-brush, thanks to a turbine system,
increases effectiveness and efficiency when
vacuuming fabric surfaces. Move the selector,
located on the back of the turbo-brush to the
right (13).
The selector, by adjusting the speed of the
turbine system, adapts the brush to any type
of surface.
The floor brush can be used by moving the
selector to the no-bristles position (4).
6.3 Press the foot pedal
start to operate at maximum power.
Adjust the suction power, as shown in Chapter
3. For this type of surface, we recommend the
Maximum level.
6.4 To end suction, press the foot pedal
the button on the handleagain.

7. CLEANING UPHOLSTERY

(mattresses, sofas, car interiors, etc.)
7.1 Make sure that chapter 1 has been completed.
7.2 Connect the mini turbobrush to the flexible
hose and pass over the surfaces.
. The appliance will
or
. The appliance will
or
| 20 |
Using the mini turbo-brush on armchairs and
sofas, car interiors etc., is particularly recom-
mended for the removal of animal fur and hair,
thanks to the mechanical action of the roller
brush. The suction nozzle with bristle frame at-
tached is particularly recommended for remo-
ving the most stubborn dirt thanks to the abra-
sive action of the bristles on the surface.
If it is not needed, the bristle frame can be re-
move from the suction nozzle by sliding the gui-
des of the frame on the base of the nozzle (5).
Use the lance for thorough vacuum cleaning
of hard-to-reach spots such as skirting-
boards and folds in sofas, armchairs, uphol-
stered furniture and car upholstery.
For the MC350 Turbo & Fresh model only it is
possible to use the flexible suction hose to
reach the most difficult-to-reach places such
as inside cars, radiators, door and window
jambs.
7.3 Press the foot pedal
start to operate at maximum power.
Adjust the suction power, as shown in Chapter
3. For this type of surface, we recommend the
Medium level.
7.4 To end suction, press the foot pedal
the button on the handleagain.
8. EMPTYING AND CLEANING THE
DUST CONTAINER
When the dust container is full, the "container
full " indicator light comes on. To empty it,
proceed as follows:
8.1 Turn off the appliance using the foot pedal
. Disconnect the power supply cable from
the mains.
8.2 Release the dust container from the va-
cuum cleaner by pulling the lever (6).
8.3 Remove the dust container lifting it by the
handle.
8.4 Press the button located on the container
in order to open the container and remove the
dirt collected (7).
WARNING: Since by operating the button
the lower base of the reservoir opens, it is
recommended that this operation be done
over a waste bin.
8.5 Remove the container cover by turning it
anti-clockwise relative to the container, ali-
gning the two reference arrows (8).
8.6 Remove the filter under the cover of the
. The appliance will
or