Idiomas disponibles
Idiomas disponibles
LD 15-10 125 R / LD 15-10 125 / LDE 15-10 125 R
NOTE
Avoid exerting excess pressure on the tool
when sanding/grinding at low speed (1-3) as
otherwise it will quickly overheat.
Using a dust extraction system
NOTE
It is recommended to use a FLEX Class M
dust extractor.
Connect extraction hose to the 32 mm
connector.
Engage extraction hose in hose support.
Connect extraction hose to the dust
extraction system. Follow the operating
instructions for the dust extraction
system! Check the attachment! If
required, use an appropriate adapter.
NOTE
If your dust extractor requires a special
connection (i.e. a connection other than the
32 mm/36 mm standard connection which
is included with the electric power tool),
contact your dust extractor supplier to
obtain the appropriate adapter.
Working with the power tool
WARNING!
The rotating sanding disc must not come
into contact with sharp projecting objects.
Danger of kickback! Damage to sanding
pad. If the sanding pad is damaged or
severely worn, it must be replaced.
CAUTION!
Hold the electric power tool with both hands!
1. Attach sanding tool.
2. Connect dust extraction system.
3. Insert mains plug.
4. Switch on dust extraction system.
5. Switch on the device.
6. Place the renovation sander on the
work surface.
The brush ring (LD 15-10 125 R /
LDE 15-10 125 R) or the rubber
extraction ring (LD 15-10 125) must be
flush with the work surface.
7. Increase the pressure to bring the
sanding pad into contact with the work
surface. In doing so, slew the renovation
sander with overlapping movements.
8. Sanding in corners (LD 15-10 125 R /
LDE 15-10 125 R):
– Switch off the power tool and wait until
the sanding tool has come to a standstill.
– Pull out pivoted edge segment and
swivel to left.
– Switch on power tool again.
9. After work, switch off the electric power
tool and pull out the mains plug.
21
