4
S
afety Information
Read carefully and thoroughly through this booklet as it contains important safety information
that will protect the user from unexpected dangers and prevent potential damage to the product.
This section is divided into 2 parts : Warning and Caution.
: This is a warning sign specifying user's applications which might
be dangerous.
: This is a sign specifying 'Strictly Forbidden' applications.
WARNING
CAUTION
WATER
HEATER
SAFETY
PROPER
INSTALLATION
: Failure to comply with the instructions under this
sign may result in major physical injuries or death.
: Failure to comply with the instructions under this
sign may result in minor physical injuries or damage
to the product.
WARNING
• Under certain conditions, hydrogen gas may be produced in a water heater that has not been used for
two weeks or more. Hydrogen gas can be explosive under these circumstances.
If the HOT water has not been used for two weeks or more, prevent the possibility of damage or injury
by turning on all Hot water faucets and allowing them to run for several minutes. Do this before using
any electrical appliance which is connected to the HOT water system. This simple procedure will
allow any built-up hydrogen gas to escape. Since the gas is flammable, do not smoke or use an open
flame or appliance during this process.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
CAUTION
• The base opening must not be obstructed by carpeting when the washing machine is installed on a
carpeted floor.
• Install or store where it will not be exposed to temperatures below freezing or exposed to the
weather.
If the product is exposed to such conditions, electric shock, fire, break down or deformation
may occur.
• Properly ground washer to conform with all governing codes and ordinances. Follow details in
Installation Instructions.
If not grounded properly, break down and leakage of electricity may occur, which may cause
electric shock.
• Must be positioned so that the plug is accessible.
If the plug is placed between the wall and the machine, it may get damaged, possibly causing
fire or electric shock.
• Make sure the plug is completely pushed into the outlet.
Failure to do so may cause electric shock and fire due to overheating.
If this appliance is supplied from a cord extension set or multi-outlet power board, the cord extension
set or multi-outlet power board must be positioned so that it is not subject to splashing or ingress of
moisture.
This appliance has been designed to operate from a 240 volt, 50Hz town power supply.
