GreenWorks WL24B00 Manual Del Operador página 7

Ocultar thumbs Ver también para WL24B00:
Idiomas disponibles

Idiomas disponibles

EN
If the battery pack or charger is damaged, replace
the battery pack or the charger.
Stop the machine and wait until the motor stops
before you install or remove the battery pack.
Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
12.5 REMOVE THE BATTERY PACK
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
13
OPERATION
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
13.1 START THE MACHINE
1. Install the battery pack or connect the power source.
2. Press the ON/OFF switch to turn the machine
on. The machine will be turned on at maximum
brightness.
3. To reduce the brightness, press the ON/OFF switch
again.
Low voltage operation
When the battery pack is less than 5%, the machine will
flash three times with a brightness of 500 lumens.
WARNING
WARNING
English
Do not continue to press the ON/OFF switch after
the machine has automatically switched off. The
battery can be damaged.
13.2 STOP THE MACHINE
1. Press the ON/OFF switch to turn the machine off.
13.3 SWIVEL THE LIGHT HEAD
1. Hold the auxiliary handle and unlock the right and
left knobs.
2. Turn the light head to the necessary position.
3. Tighten the knobs.
14
MAINTENANCE
Remove the battery pack from the machine before
maintenance.
Do not use strong solvents or detergents on the plastic
housing or components.
14.1 CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks of
electrical shocks.
Clear the unwanted material out of the air vent with
a vacuum cleaner.
Do not spray the air vent or put the air vent in
solvents.
8
WARNING
WARNING
WARNING
CAUTION
loading

Este manual también es adecuado para:

Wlg503