LG LT1016CER Manual Del Propietário página 19

TEMPERATURE CONTROL
The thermostat monitors room temperature to maintain the desired temperature.
The thermostat can be set between 60 F~86 F (16 C~30 C).
REMOTE CONTROL SENSOR
CLEAN FILTER
7
'Clean Filter' LED will light up to notify you that your filter needs to be cleaned.
After cleaning the filter, press "Temp
(Filter reset must be done from unit control panel not remote control).
This feature is reminder to clean the Air Filter (See Maintenance) for more efficient operation.
The LED (light) will illuminate after 250 hours of operation.
During operation in failure of electric power, the unit runs as previous setting operation.
ENERGY SAVER ENERGY SAVER
The unit defaults to Energy Saver mode each time the unit is switched on except
restoration after an electrical power outage and fan mode.
CAUTION
The remote controller will not function properly if strong light strikes the sensor of the air
conditioner or if there are obstacles between the remote controller and the air conditioner.
1. Push out the cover on the back of the remote control with your thumb.
2. Pay attention to polarity and insert one new AAA 1.5V battery.
3. Reattach the cover.
Do not ure rechargeable battery. Make sure that the battery is new.
Do not mix alkaline, standard (Carbon-zinc) or rechargeable (Nickel-cadmium)
battery.
- In order to prevent discharge, remove the batteries from the remote control if
the air conditioner is not going to be used for an extended period of time.
Keep the remote control away from extremely hot or humid places.
To maintain optimal operation of the remote control, the remote sensor should
not be exposed to direct sunlight.
" together to turn off 'Clean Filter' light.
y
Operating Instructions
Owner's Manual 19