Tabla de contenido
To enable the channel scan mode:
- From standby mode,momentarily press the Power On/Off
Button; SCAN will appear on the LCD display.
- The radio will automatically display each channel (1-8) in
ascending order to find an active main channel.
- When the unit doesn't find any signals and you want to
transmit, press the PTT Button to return to primary channel
operation. The transceiver will automatically resume scanning
approximately 15 seconds after the communication is completed.
- If there is no activity and you want to leave the scan mode,
press the Power On/Off button momentarily and the unit will
return to normal operation; the SCAN icon will disappear from
the LCD display.
Battery Alert
When the low battery icon (
panel, recharge the unit or install fresh batteries.
Warning
Remove the batteries from the transceiver if it is not expected
to be used for long periods.This will eliminate the possibility of
chemicals leaking from the batteries and corroding the
transceiver.
Avoid exposing the transceiver to water or extremes of
temperature.
Do not use this device in or near a mining facility, which uses
remotely triggered explosives or in areas labeled "Blasting
Area".
Do not attempt to modify or in any way increase the output of
this transceiver. Its output is designed to meet the legal limits.
Do not use this device or charge its batteries in potentially
explosive atmospheres. Turn your transceiver off wherever
posted notices restrict the use of radios or cellular telephones.
Facilities such as hospitals may use equipment that is
sensitive to RF energy.
Turn your transceiver off on board aircraft when requested to
do so.
Do not place your radio in front of a vehicle's air-bag. If the
air-bag deploys, it could propel the transceiver like a projectile
causing bodily injury.
) blinks steadily on the LCD
8
Tabla de contenido
