Tabla de contenido
- The CTCSS subcode (01-38) will be displayed on the LCD
panel if the CTCSS tone frequency function is enabled(not oF).
Channel Selection
- From standby mode, press the MODE button once;
the channel number flashes.
- Press the Up or down button briefly to move to the desired
channel number.
- Press the PTT button momentarily to confirm selection.
CTCSS Mode (Sub-Channel) Selection
- From standby mode,press the MODE Button twice; a flashing
oF or sub-channel number is displayed.
- Press the Up or Down button to select the desired sub-channel
for use(01-38)
- Press the PTT button to confirm selection.
- The CTCSS mode can be turned off by selecting oF as the
setting.
NOTE :
To communicate with other PMR units, they must be
switched to the same channel and CTCSS subcode. To
communicate with other PMR units that do not have subcodes,
switch your unit to the same channel with the subcode set to oF.
The CTCSS subcodes do not prevent others from hearing your
transmisstion.This will only allow you to ignore all traffic on a
given channel not using the same subcode.
VOX Mode Selection
When your voice or signal is detected using the internal
microphone/headset (purchased separately), the radio transmits
automatically without the need to press the PTT button.
To enable the VOX operation:
- From standby mode, press the MODE button 3 times unitil the
blinking VOX icon (
- Press the Up or Down button to select the VOX on or oF as
desired.
- Press the PTT button momentarily confirm selection.
- When enabled, the VOX icon (
Rogrer Beep Tone
The Roger Beep is a tone which is automatically transmittied
whenever the PTT button is released.
) appears with on or oF.
) appears.
6
Tabla de contenido
