Idiomas disponibles
Idiomas disponibles
time.
Configuring the Thermometer
This weather station is equipped to synchronize up to 3 remote temperature sensors.
One remote temperature sensor is included. Additional remote temperature sensor is
available for purchase separately. Please contact your local distributor for purchase.
Remote temperature sensors
RTS 1.
RTS 2.
RTS 3.
RTS 4.
RTS 5.
Batteries installation
1. Open battery compartment on the back of the unit by removing the
two small screws (RTS 2) with a Philips head screwdriver. (see fig. 4)
2. Install/ replace 2 x AAA size batteries in the compartment. It is
recommended that only alkaline batteries are used. Do not use
rechargeable batteries.
3. The weather station is capable of receiving up to 3 different channels.
Select the channel number (1, 2, or 3) by sliding the CHANNEL123
switch (RTS 5). If you only have 1 remote temperature sensor, select
1.
4. Press the RESET button (RTS 4) once and the red light will flash once.
5. Replace the battery compartment on the back of the unit by tightening
the two screws (RTS 2).
Installation
1. Place the remote temperature sensor at a desired place by mounting
the unit's hang hole (RTS 1) on a screw (screw not included).
Alternatively, the unit can be place on a flat horizontal surface.
2. The unit can be placed indoor or outdoor. The unit is weather proof.
Do not submerge unit in water. Do not expose unit to water for
prolonged periods. Avoid accumulation of water and or snow on unit.
Avoid exposing unit to direct sunlight. Remove unit from the exterior in
Fig. 4 Back View
Hang hole
Battery compartment screws
TX button
RESET button
CHANNEL 123 switch
Fig. 5 Back view - open
