Idiomas disponibles
Idiomas disponibles
During the charge process, the current used should correspond to the current
of the battery charger.
Never let moisture, rain or splashed water reaches the charging location.
The ambient temperature must not exceed 40 °C. Never expose the device to
direct insulation.
Storage-battery packet, which are defective or damaged or can no longer be
recharged, must be disposed of as hazardous waste. Hand them over at a
special collection point. Never harm our environment. Do not throw unusable
storage-battery packet away into the domestic waste, into fire or into water.
If the electrical cable is damaged, the wire may only be replaced by the
supplier or by his repair workshop. Have repairs carried out only by an
authorized specialist only.
Use only storage-battery packet, which have been produced by the original
manufacturer.
Always keep the surface of the charger free from dust and dirt.
Insert the battery packet into the charger. Follow the guidelines provided
concerning polarity.
Always remove battery packet before working on the machine
When the battery packet is outside the drill, cover the contacts to avoid short
circuits (e.g. from tools)
Do not throw batteries into water or fire, risk of explosion!
Protect the battery packet from impacts, and don't open it.
Never discharge the battery packet completely and recharge occasionally if
not used for a prolonged period
7.2 R
ESIDUAL RISKS
Even when the tool is used as prescribed it is not possible to eliminate all residual risk
factors.
The following hazards may arise in connection with the tool's construction and
design:
Damage to lungs if an effective dust mask is not worn.
Damage to hearing if effective hearing protection is not worn.
Health defects resulting from vibration emission if the power tool is being
used over longer period or not adequately managed and properly maintained.
