Idiomas disponibles
Idiomas disponibles
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth has to be connected!
Lighting effects must not be connected to dimming-packs.
OPERATION
After you connected the effect to the mains, the CY-250 starts running. During the Reset, the motors are
trimmed and the device is ready for use afterwards.
Turn the objective-lens for adjusting the focus in order to obtain a sharp projection.
Stand Alone operation
In the Stand Alone mode, the CY-250 can be used without controller. You can do without a controller as the
CY-250 features a built-in microphone, which provides automatic sound control.
Disconnect the CY-250 from the controller and select "Master Mode: Sound-control".
If you have connected a footswitch to the Blackout-socket, you can lock the light output (Blackout-mode) and
turn it on again.
Master/Slave-operation
Connect the master and slave-devices and adjust the settings as desribed above.
Please note: If you wish to change from one operating mode into another, you have to unplug the projector
from the mains and plug it again.
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. In order to call up the different features, you first have to open the shutter
(control channel 6, DMX-value 132-139 or 250-255) or set the dimmer to the desired intensity (control
channel 6, DMX-value 6-128).
Addressing
The Control Board on the front side of the base allows you to assign the DMX fixture address, which is
defined as the first channel from which the CY-250 will respond to the controller.
If you set, for example, the address to channel 7, the CY-250 will use the channel 7 to 14 for control.
Please, be sure that you don't have any overlapping channels in order to control each CY-250 correctly and
independently from any other fixture on the DMX data link.
If two, three or more CY-250 are addressed similarly, they will work similarly.
For address setting, press the Mode-button until the display shows "d" and set the desired address via the
Up/Down-buttons.
Controlling:
After having addressed all CY-250, you may now start operating these via your lighting controller.
All manuals and user guides at all-guides.com
25/52
51837530X18NXS_V_1_0.DOC
