Concept SM 3050 Manual Del Usuario página 60

EN
Manual operation
1. Press a desired speed button single time to start blending. The display shows a time 1:00, which is preset
for this operating speed. All other indicators will go out except the power indicator, which will be flashing,
the indicator of the selected speed and the + 20s button. Other buttons will be illuminated lightly.
2. During operation, you can adjust the set speed and time. Press the manual speed adjustment button once
to increase or decrease the speed. Press the "+20" button once to prolong the set time by 20 seconds.
3. In the manual mode, please, first 5 seconds blend at a low speed. Then you can gradually increase the
speed.
4. The blender has 8 different preset speeds. The maximum time, which can be set, is 10 minutes.
Switching to the "Completed" mode
The blender shows 0:00 and beeps 5 times, which means a cycle is completed. The power indicator will
be flashing and the other buttons will light up. When a cycle of a function is completed, you can press
the "ON/OFF" button to switch the blender to the standby mode, but this action can be done only if the
container is still on at the base. The blender switches to the standby mode automatically after 30 seconds.
Clean the container and base according the instructions. You can store the blender.
TROUBLESHOOTING
Problem
The indicator on the
control panel does not
1
light after putting the
container on the base.
The blender suddenly
2
stops during operation.
6 0
Cause
The plug is disengaged or partly
disengaged.
Power blackout.
Power blackout.
Two function buttons have been
accidentally pressed at the same
time.
Too much food jammed the motor.
Long operation activates
protection the motor overheating
protection.
A sudden addition of a large
amount of food activates the over
current protection.
Solution
Insert the plug firmly into
a wall outlet.
Wait for power recovery.
Wait for power recovery.
Press the desired button.
Remove some food and put
the blender back into
operation.
Turn the blender on again
after 30 to 40 minutes.
Unplug the blender from
a wall outlet for 20 to 30
minutes, then re-plug it in
and turn the blender on
again.
SM 3050