Idiomas disponibles
Idiomas disponibles
Problem
Solution
The radio does not
The radio may be defective. Contact the Philips Consumer Care
work.
Centre in your country.
Perhaps you set the volume too low. Increase the volume level.
The radio produces a
Perhaps the broadcast signal is weak. Adjust the frequency (see
crackling sound.
chapter 'Using the appliance' section 'Radio/volume') and/or change the
position of the antenna by moving it around. Make sure you have
unwound the antenna completely.
The alarm went off
Perhaps you switched off the alarm function by setting the control
yesterday, but it did not
lever to the top position.
go off today.
Perhaps you set a sound level and/or light intensity level that is too
low. Set a higher sound and/or light intensity level.
Perhaps there was a power failure that lasted more than
approximately 15 minutes. In this case the appliance goes back to
factory settings. You need to set all functions again.
The alarm did not go off
Perhaps you pushed the control lever down with so much force that it
9 minutes after I pushed
jumped to off position.
the control lever down
to snooze.
Perhaps you set the volume level to OFF.
The light wakes me too
Perhaps the light intensity level you have set is not appropriate for you.
early.
Try a lower light intensity level if you wake up too early. If light intensity
1 is not low enough, move the appliance further away from the bed.
The light wakes me too
Perhaps the appliance is positioned at a lower level than your head.
late
Make sure the appliance is located at a height at which the light is not
blocked by your bed, duvet or pillow. Also make sure the appliance is
not placed too far away.
The lamp flashes.
Perhaps the appliance is not suitable for the voltage to which it is
connected. Make sure that the voltage indicated on the appliance
corresponds to the local mains voltage.
All manuals and user guides at all-guides.com
EnglisH
13
