Idiomas disponibles
Idiomas disponibles
Use a vacuum cleaner, pressurized air, or a
small, soft bristled brush to clean.
A yellow tip on the pilot flame indicates dust
and dirt in the pilot assembly. There is a small
pilot air inlet hole about 2" from where the
pilot flame comes out of the pilot assembly
(see Figure 35). With the unit off, lightly blow
air through the air inlet hole. You may blow
through a drinking straw if compressed air is
not available.
Air Passageways
Use a vacuum cleaner or pressurized air to
clean.
• If you remove logs for cleaning, refer to Installing Logs, page 18, to properly replace logs.
• Replace log(s) if broken or chipped (dime-size or larger).
WARNING: If you smell gas:
• Shut off gas supply.
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your
building.
• Immediately call your gas supplier from a neighbor's phone. Fol-
low the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
WARNING: Only a qualified service technician should service and
repair heater. Make sure that power is turned off before proceeding.
Turn off and let cool before servicing.
CAUTION: Never use a wire, needle, or similar object to clean
ODS/pilot. This can damage ODS/ pilot unit.
IMPORTANT: Operating heater where impurities in air exist may create odors. Cleaning supplies,
paint, paint remover, cigarette smoke, cements and glues, new carpet or textiles, etc., create fumes.
These fumes may mix with combustion air and create odors. These odors will disappear over time.
Note: All troubleshooting items are listed in order of operation.
24
CARE AND MAINTENANCE
ODS/PILOT
CABINET
LOGS
TROUBLESHOOTING
www.usaprocom.com
Ignitor
Natural Gas
Electrode
Burner
Pilot Air
Inlet Hole
(Back of pilot
shown for clarity)
Figure 35 - Pilot Inlet Air Hole
Exterior
• Use a soft cloth dampened with a mild soap
and water mixture.
• Wipe the cabinet to remove dust.
Thermocouple
Propane/LP
Gas Burner
Pilot Air Inlet Hole
200133-01A
