Batteries: Preparation; Batteries: Installation And Connection - IPC CT160 Manual De Instrucciones

The technical characteristics must correspond to those indicated in the paragraph on the
technical specification of the machine. The use of heavier batteries could seriously
jeopardise manoeuvrability and lead to the brush motor overheating. Batteries with a
lower capacity and weight will require charging more frequently.
They must be kept charged, dry and clean and the connections must be tight.
Follow the instructions below to set the machine's software for the type of battery
installed:
1. with the machine off, hold the buttons P1 (fig. B, ref. 1) and P3 (fig. B, ref. 2) down
simultaneously and then start the machine by turning the ignition key (fig. B, ref. 3)
to "1".
2. press the settings button (fig. B, ref. 4) 3 times.
3. press the "flow regulation" buttons (fig. B, ref. 5) to select the type of battery
installed on the machine "ACd" for acid battery (tubular leak-proof batteries) or
"GEL" (GEL batteries).
4. memorise the parameter displayed by holding the settings button (fig. B, ref. 4)
down until the battery voltage is displayed.

5.4.1. Batteries: preparation

While installing or performing maintenance on the batteries, the operator must be
provided with the necessary personal protection devices (gloves, goggles, overalls,
etc) to limit the risk of accident. Keep away from naked flames, avoid short
circuiting the battery poles, avoid sparks and do not smoke.
The batteries are normally supplied filled with acid and ready for use.
If the batteries are dry, before mounting them on the machine, proceed as follows:
• remove the caps and fill all elements with specific sulphuric acid solution until the
plates are entirely covered (this requires at least a couple of passes for each element);
• leave for 4-5 hours to allow the air bubbles to come to the surface and the plates to
absorb the electrolyte;
• make sure the level of electrolyte is still above the plates and if necessary top up with
sulphuric acid solution;
• close the caps;
• mount the batteries on the machine (following the procedure described below).
Before starting up the machine for the first time, charge the batteries as follows.

5.4.2. Batteries: installation and connection

Check that all switches on the control panel are in the "0" (off) position.
Make sure you connect the terminals marked with a "+" to the positive poles of the
battery. Do not check the battery charge by sparking.
Follow the instructions given below meticulously as shortcircuiting the batteries
could cause them to explode.
CT160
•
Make sure the dirty water tank is empty and empty it if necessary (see relevant
paragraph).
•
Lift the dirty water tank (fig. C, ref. 5) and tilt it backwards to access the battery
compartment (fig. C, ref. 2) from the top, Rotate the seat cowling (fig. C, ref. 4)
forwards.
ENGLISH
10
i INFORMATION
! DANGER
! DANGER