Idiomas disponibles
Idiomas disponibles
WARNING: IMPORTANT!
BEFORE LIGHTING
Inspect the gas supply hose prior to turning the gas
"ON". If there is evidence of cuts, wear, or abrasion,
it must be replaced prior to use. Do not use the grill
if the odor of gas is present. Only the pressure
regulator and hose assembly supplied with the unit
should be used.
Never substitute regulators and hose assembly for
those supplied with the grill. If a replacement is
necessary, contact the manufacturer for proper
replacement. The
replacement must
specified in the manual.
WARNING: Always keep your face and body as
far away from the burner as possible when
lighting.
TO LIGHT THE MAIN BURNER
Make sure all knobs are "OFF" then turn on the gas
supply. Always keep your face and body as far from
the grill as possible when lighting.
Keep a spray bottle of soapy water near the gas
supply valve and check the connections before
each use.
Do not attempt to light the grill if odor of gas is
present. Call for service U.S.A:1-800-913-8999.
Each burner is adjusted prior to shipment;
however, variations in the local gas supply may
make minor adjustments necessary.
To light your main burner, push and turn main burner control
knob to"
ignition button to light the burner. Once the burner is lit,
release the electronic ignition button and knob. If the burner
does not light wait 5 minutes for any excess gas to dissipate
and then retry.
be
that
TO LIGHT THE SEAR BURNER
To light the sear burner, remove any cooking utensils from
the burner grate. Push and turn the control knob to "
the same time, press and hold electronic ignition button to
light the burner . Once the burner is lit, release the electronic
ignition button and knob. If the burner does not light, turn the
control knob to "○". If the smell of gas is detected and the
igniter is not functioning, immediately turn the control knob to
"○". Allow 5 minutes for any accumulated gas to dissipate. If
the sear burner igniter is not functioning, see the following
section for match lighting.
8
Grill Lighting Instructions
A. Closed valve
B. Open valve
", at the same time, press and hold electronic
", at
