Putting Into Service; How To Operate - HAEGER Home Wind Instrucciones De Uso

Putting into Service

Position
The ideal position is a non-slip, flat surface.
Do not place the device immediately next to stoves or other sources of heat.
Electrical Connection
1. Connect the device to a duly installed 220-240V~50/60Hz protective contact
socket.
2. Before inserting the plug into the socket. Make sure that the mains voltage
to be used matches that of the device. You can find this information on the
nameplate.

How to operate

1. Turn the speed control (2) and set to the correct position depending on the
air flow desired:
1– Low,
You can select the positions on either the left or right half of the selector.
2. Put the LOUVER switch (1) in position MOVE if you would like the front grille
(5) to rotate for increased air circulation. The front grille can rotate in both
directions (to the left or to the right). The rotation direction is random.
3. Set the timer (3) to the desired position according to how long you want the
fan to operate (0-60). Once the selected time has elapsed, the timer will
stop in the OFF position and the fan will switch itself off. If you would like the
fan to operate continuously, put the timer (3) in position ON.
4.
Set the speed control (2) to position 0 to switch off the fan.
Cleaning
Clean the surface of your fan with a dry cloth if it is covered by dust.
•
Usually pay attention to the operation. If the blade doesn't rotate freely or, it
•
sounds any in normal noise, please refer to your supplier!
Use a vacuum-cleaner to suck out the dust of the blade, the grilles and the
•
inner parts.
Important Note:
Do keep your fan disconnected to the electricity before doing any
maintenance!
Instructions for use
2 – Medium, 3 – High
English
3