Idiomas disponibles
Idiomas disponibles
8. Blade Assembly.
WARNING: To reduce the risk of serious bodily injury,
DO NOT use power tools to assemble the blades. If
screws are overtightened, blades may crack and break.
Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 27 blade attachment screws and washers in one
of the hardware packs. Place blade arm on UNDERSIDE
of blade, aligning holes in blade arm with holes in blade
as shown. Insert 3 blade attachment screws (along with
washers) from TOPSIDE of blade with fingers first and
then tighten screws securely with a Phillips screwdriver.
Repeat procedure for remaining blades.
Locate 18 blade arm screws/washers in hardware pack.
[If plastic motor locks are installed with blade arm screws,
discard plastic motor locks.] Align blade arm holes with
motor screw holes and attach blade arm with blade
arm screws/lock washers. Before securing screws
permanently, repeat with remaining blade arms.
Securely tighten all screws.
NOTE: Tighten blade arm screws twice a year.
9. LED Light Kit Assembly.
Remove 1 screw from motor plate on underside of
motor housing and partially loosen the other 2 screws.
Align slotted holes in fitter plate with loosened screws
in motor plate, allowing molex connections from motor
housing to come through holes in midde of fitter plate.
Twist fitter plate to lock. Re-insert screw that was just
removed and securely tighten all 3 screws with a Phillips
screwdriver.
Remove 1 screw from underside of fitter plate and
partially loosen the other 2 screws.
Connect WHITE wire from LED light kit to WHITE wire
from motor housing. [Note: It may be necessary to pull
back sleeve on wires on motor housing to note the
color.] Connect BLACK wire from LED light kit to BLACK
(or BLUE) wire from motor housing. Be sure that molex
connections snap together completely.
WARNING:
Do NOT connect molex connections for the
LED light kit if you do NOT wish to use the light kit.
Carefully arrange wiring within fitter plate. Align slotted
holes in LED light kit with loosened screws in fitter plate.
Twist LED light kit to lock. Re-insert screw that was
previously removed and tighten all 3 screws securely.
Align grooves on shade with nodules on inside of LED
light kit and push up gently on shade. Twist shade to the
RIGHT (clockwise) until shade locks into place.
Pull down VERY GENTLY on shade to make sure that shade
is secure.
["Light Kit Assembly" continued on next page.]
blade arm screws/
lock washers
molex
connections
page 8
motor housing
blade attachment
screws and washers
blade
blade arm
motor housing
motor plate
fitter plate
motor housing
fitter plate
LED light kit
nodules
shade
grooves
