Idiomas disponibles
Idiomas disponibles
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Pull the safety bond through the attachment eyelet and over the trussing system or a safe fixation spot.
Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
OPERATION
After you connected the effect to the mains, the FF-4 starts running.
Connect the remote control with the Remote Control-socket.
The buttons have the following functions:
Smoke Smoke output
Sound Sound-controlled beam-movement
Flash
Press the Sound-button for 3 seconds in order to activate the blackout (light source
shut off). The LED next to the Flash-button flashes. Press the Sound-button again for
3 seconds in order to deactivate the blackout.
After a certain warm-up time (red LED in the tank), the device is ready to operate.
Then the blue LED in the tank lights up. By operating the smoke switch on the remote
control the smoke emission starts. It may happen that the blue LED turns off and the
smoke emission stops. In this case the device is heating up again and will be ready to
operate in approx. 1-2 min. This process guarantees an appropriate vaporization temperature and the best
smoke emission possible. The temperature is regulated by a high quality thermostat.
CAUTION: The escape nozzle will heat up during operation. Therefore do not touch the nozzle until it
has cooled down completely.
DANGER TO LIFE!
International
L
N
Continuous beam-movement
17/35
00046274.DOC, Version 1.1
