The vacuum cleaner may be stored in a vertical or horizontal po-
sition. The hose can remain attached to the vacuum cleaner, but
please be careful not to bend it too much during storage.
CLEANING AND CARE
Empty the dust bin
Unplug the power cord from the power wal outlet before cleaning.
Empty the dust container, when the vacuum cleaner becomes loud-
er or when the suction power has decreased. Check if dust container
is full after each use. If necessary, empty the container.
•
Hold the dust container and press the release button.
•
Remove the dust container from the appliance.
•
Open the top cover of the dust container, then empty the dust
into the waste bin.
If the vacuum cleaner loses power, check how full the container is. If
the dust container is not full, check whether the suction brush or the
hose or tube is blocked with large items stopping the air flow. After
removing any obstruction, start the appliance again.
Clean and replace the inlet filter
•
Before cleaning the filter, remove the power cord plug from
the wall outlet.
•
The filter shall be cleaned when there are visible stains on it,
wash the filter in warm water with no detergent. Use it only
when completely dry.
•
Always use the vacuum cleaner with a filter in place.
•
Failure to install the filter may result in motor damage.
1. Remove the filter by sliding it out of the guides upwards.
2. Clean the filter or replace with a new one.
3. Reinstall the filter by placing it back into the guides. Ensure the
filter is completely dry before inserting it.
CLEAN AND REPLACE THE EXHAUST FILTER
•
Before cleaning the filter, remove the power cord plug from
the wall outlet.
•
Clean the filter when it is clearly soiled. Shake dirt off the fil-
ter and then brush it with a soft bristle brush. Then rinse the
filter in lukewarm water and do not use any detergent. Do
not direct strong jet of water onto the filter. Use it only when
completely dry. If the filter is too dirty or damaged replace the
filter with a new one.
•
Depending on the intensity of use, it is recommended that
you clean the filter once a month and replace it with a new
one every six months.
•
Always use the vacuum cleaner with a filter in place.
•
It is recommended that you only use original Amica filters for
your vacuum cleaner.
Note! Figures are for illustrative purposes only. Individual models
may vary.
1. Open the air exhaust cover.
2. Remove the filter from the back of the vacuum chamber.
3. Clean it or replace it with a new one.
Cleaning filters.
Rinse the filter with warm water and let dry completely.
In the event of any fault:
•
Turn off the appliance:
•
Unplug the appliance from power
•
By following the instructions given in the table below, you can
correct some minor issues. Please check all points in the table
before you refer the repair to customer service.
Problem
1. The appliance
does not work
2. Reduced suction
power of the vacu-
um cleaner
If the problem is not solved, unplug the appliance from power and
report the fault to the nearest service centre. Note! All repairs must
be performed by qualified service technicians.
7
Reason
Remedy
No power
Check the circuit
breaker, reset if
tripped, replace a
blown fuse
Vacuum cleaner
Remove dust, hair,
hose clogged
and other obstruc-
tions that may
reduce airflow.
EN