Idiomas disponibles
Idiomas disponibles
How To Use
Oscillating
ON/OFF Button
Mist Decrease
Button
Mist Indicator
Light Ring
Power Button
Plug unit in to a 120 volt AC electrical outlet. Push the POWER ON/OFF ( ) button to turn unit on.
ATTENTION: When the water in the tank is almost empty, the humidifying function will power
off to indicate to the user to refill the tank.
Mist Increase and Decrease
There are 5 different levels of mist output from Lowest to Highest. To increase the mist output,
press the MIST INCREASE (
) button until the desired mist output is reached. The selected
mist level will correspond to the number of sections lit along the mist indicator light ring.
When the maximum mist output has been reached, the indicator ring light will blink once. To
decrease mist, press the MIST DECREASE ( ) button until the mist has decreased to the
output level desired. When the minimum mist output level has been reached, the indicator ring
light will blink once. (Fig.2)
Warm and Cool Mist Control
The humidifier is equipped with the option to select warm or cool mist. Each time the unit is
turned on it will start producing cool mist. The mist indicator light ring will glow with a blue light.
To select Warm Mist, press the WARM/COOL MIST button. When warm mist is selected, the
mist indicator light ring will change from blue to red and warm mist will start being produced.
To return to cool mist, press the WARM/COOL MIST button again. The mist indicator ring will
change from red to blue. (Fig.2)
NOTE: Once warm mist is selected, it will take 15 minutes to heat up before the mist
becomes warm.
Warm/Cool Mist
Button
Mist Increase
Button
Power ON/OFF
Button
Fig. 2
6
Oscillation
When the humidifier is producing mist, press the OSCILLATION ON/OFF (
the motorized oscillation feature. The nozzle at the top of the unit will oscillate in a 120° range
from side to side. To target the nozzle and mist in a fixed direction, press the OSCILLATION
ON/OFF (
) button when the nozzle is at the desired position and the nozzle will stop and
direct mist to the desired area only. (Fig.2)
NOTE: The oscillation feature will not operate if the humidifying function is not operating.
Oscillation feature will only work when mist is being produced.
How to Fill
CAUTION: Before filling unit with water, turn the power off and unplug the unit from the outlet.
NOTE: Always use two hands to carry the water tank.
1. To release the tank from the unit, place your fingers with your
Fig. 3
palm facing upward into the recess in the tank handle. Press the
tank release button with your thumb. (Fig. 3)
2. Pull the water tank away from the humidifier base by the
Fig. 4
handle and remove the water tank from the base by lifting it up
and away. Be sure not to tip or tilt the base while removing the
tank. (Fig. 4)
3. Turn the tank upside down – remove the tank cap
Fig. 5
Fig. 5
by turning it counter-clockwise. (Fig. 5)
) button to turn on
7
