Power Dynamics PD612A Manual De Instrucciones página 3

REAR PANEL
1. Balanced combi connector: XLR input /
Jack 6.3mm (1/4") input.
2. Input sensitivity switch;
Line: normal mode
Mic: the input sensitivity is set to MIC
level, suitable for the direct connection of
a dynamic microphone. Do NOT use this
setting when connected to a mixer
output!
3.
Volume control channel 1
4. Balanced XLR Input
5. RCA Line output
6.
Volume control channel 2
7.
Amplifier volume control. Turn it either
clockwise to increase the volume or
counter clockwise to decrease.
8. DSP Mode
a. Flat
b. Contour
c. Voice
d. DJ
9. Balanced parallel XLR output. This output is linked in parallel with the audio input and is useful to connect another
amplifier.
10. Power LED
When lit, the power is on.
11. Signal LED
When lit, the signal presence at the audio input.
12. Power Switch
Push to turn ON / off the amplifier. Before
switching the amplifier on, check all connections
and turn fully counter clockwise the volume control
(7).
13. Fuse 220-240V~ T3.15 AL 250V
14. Power cord input
Before connecting the power cord, check if the mains corresponds to the voltage indicated on the rating plate on the
unit. Connect the power cord only to a mains socket outlet with a protective earthing connection.
3